EOD Wire Attack Kit

SKU:
EOD88V
$1,449.34
(No reviews yet) Write a Review

EOD Wire Attack Kit 

eod-wire-attack-kit.jpg

The EOD Wire Attack Kit, includes all of the above, the Fluke 88V multi-meter, 6 Pair Lead Wires with 6 Pair Wire Insulation Penetrating Probes, Fluke TL224 Lead Wires to connect piercing probes to your 88V, 9V Battery and 88V Instruction Manual and Berry Compliant EOD-Specific Rip Away Pouch.

PRO NOTE: The TBT Program requires 6 lead pairs to run diagnostics during your problems.  Our wire piercing probes are color coded but if you're using another set that aren't color coded, we recommend that you color code each pair with a colored piece of tape so that you know when each lead is or is not to be use.

 

Voltage (AC): 600 mV-1000

Voltage (DC): 600 mV-1000

 

Display: LCD

Capacitance Range: 10.00 nF-9, 999 F

 

Frequency Range (Hz): 199.99-199.99 K

Amps AC: 60mA-10

 

Basic DC Accuracy: +/-0.1% +1 Dig.

Safety Rating: CAT IV 600 V, CAT III 1000 V

 

Manufacturers Warranty Length: Limited Lifetime

Ohms: 600-50M

 

Pulse Width: 0.002-1999.9 mS

Duty Cycle: 0-99.9%

 

Temp. Range: -200 To 1090C, -328 To 1994F

 

Used by EOD commands in the military and the FBI Tactical Bomb Techs, this kit gives you everything you need to measure current, detect inline resistors by seeing the current differences and make your calculations to determine circuit speeds.

 

Made by Fluke so you know the unit is well fuzed and shielded.

 

Super fast and extremely accurate continuity checks that other volt meters just can't produce.  Fast cycling giving you the accurate read you need without drifting like lessor quality models.

 

Rubber coated body protects the unit from all of the hard knocks Techs are known for.

 

Recessed selector switch to prevent accidentally changing your setting.  Loud audible beeps even when it's a super fast read.

   

Get the meter that other manufacturers use to test their voltmeters before shipping out.

 

 

 

   



Shipping Cost:
Calculated at Checkout